The New version of the German torque calibration standard DIN 51309:2005-12 a comparative overview |
|---|
| D. Röske |
- Abstract:
- In December 2005, the new version of the DIN 51309 was issued by DIN, the German Institute for Standardization. This standard takes into account some fundamental ideas about the target application of a torque transducer, for example high-level inter-comparison measurements or measurements in industrial environments. Two cases are considered and two different calibration results are calculated on the basis of a standard calibration procedure. For some intercomparisons, the hysteresis of the transducer does not have any influence on the result and is therefore excluded. This paper shows, on the one hand, the new version in comparison with other standards (e. g. EA-10/14) and some guidelines of the DKD, the German Calibration Service, and describes, on the other hand, its application to torque reference machines.
- Keywords:
- torque, calibration standard, DIN51309, hysteresis, torque reference machine
- Download:
- IMEKO-TC3-2007-KL-101u.pdf
- DOI:
- -
- Event details
- IMEKO TC:
- TC3
- Event name:
- Cultivating Metrological Knowledge
- Title:
20th Conference on Measurement of Force, Mass and Torque (together with 3rd TC16 Conference on Pressure Measurement & 1st TC22 Conference on Vibration Measurement)
- Place:
- Merida, MEXICO
- Time:
- 27 November 2007 - 01 December 2007