Comparison of Shock and Sine Force Calibration Methods |
|---|
| M. Kobusch, A. Link, A. Buss, T. Bruns |
- Abstract:
- This paper is concerned about the comparison of two important calibration methods for dynamic forces, namely the shock force calibration and the sine force calibration. Example measurements for three different types of force transducers are presented and analyzed by means of a simple mechanical model. The model describes the dynamic behaviour of the considered calibration setup including the transducer’s input-output response and identifies its characteristic parameters.
- Keywords:
- force transducer, sine excitation, shock excitation, modelling, parameter identification
- Download:
- IMEKO-TC3-2007-007u.pdf
- DOI:
- -
- Event details
- IMEKO TC:
- TC3
- Event name:
- Cultivating Metrological Knowledge
- Title:
20th Conference on Measurement of Force, Mass and Torque (together with 3rd TC16 Conference on Pressure Measurement & 1st TC22 Conference on Vibration Measurement)
- Place:
- Merida, MEXICO
- Time:
- 27 November 2007 - 01 December 2007